User manual MAKITA 9563Z

[. . . ] Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglass-reinforced wheels. Check the wheel carefully for cracks or damage before operation. [. . . ] Position the tool so that the power cord always stays behind the tool during operation. If working place is extremely hot and humid, or badly polluted by conductive dust, use a short-circuit breaker (30 mA) to assure operator safety. Do not use the tool on any materials containing asbestos. Ensure that ventilation openings are kept clear when working in dusty conditions. If it should become necessary to clear dust, first disconnect the tool from the mains supply (use non metallic objects) and avoid damaging internal parts. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel guard. Mount the wheel guard with the tab on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard 180° clockwise (for 9560Z and 9563Z) or Counterclockwise (for 9561Z, 9562Z, 9564Z and 9565Z). CAUTION: Before plugging in the tool, always check to see that the switch actuates properly and returns to the ``OFF'' position when the side of the switch lever is depressed. to start the tool , slide the switch lever toward the ``I'' position. For continuous operation, press the front of the switch lever to lock it. CAUTION: After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down. Turn the tool on and then apply the wheel or disc to the workpiece. In general, keep the edge of the wheel or disc at an angle of about 15° ­ 30° to the workpiece surface. During the break-in period with a new wheel, do not work the tool in the B direction or it will cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both A and B directions. wARNING: · It should never be necessary to force the tool. the weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. ⷠContinued use of a worn-out wheel may result in wheel explosion and serious personal injury. [. . . ] To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. [. . . ]