User manual MAKITA 9566C

[. . . ] Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. 1 2 3 4 5 Wheel cover Screw Lever Bearing box Press 6 7 8 9 10 Shaft lock Lock nut Depressed center wheel Inner flange Lock nut wrench 11 12 13 14 15 Shaft lock Switch lever Exhaust vent Inhalation vent Speed adjusting dial Depressed center wheel diameter/Spindle thread No load speed (min-1) Overall length Net weight · Due to our continuing program of research and development, the specifications herein are subject to change without notice. Note: Specifications may differ from country to country. [. . . ] Constant speed control Electronic speed control for obtaining constant speed. Possible to get fine finish, because the rotating speed is kept constantly even under the loaded condition. Soft start feature Safety and soft start because of suppressed starting shock. Overload protector When the tool would be employed over the admissible load, it will stop automatically to protect the motor and wheel. When the load will come to the admissible level again, the tool can be started automatically. Press the shaft lock to prevent spindle rotation when installing or removing accessories. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel. mount the inner flange onto the spindle. Fit the wheel on over the inner flange and screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. CAUTION: After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down. Turn the tool on and then apply the wheel or disc to the workpiece. In general, keep the edge of the wheel or disc at an angle of about 15° ­ 30° to the workpiece surface. During the break-in period with a new wheel, do not work the tool in the B direction or it will cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both A and B directions. wARNING: · It should never be necessary to force the tool. the weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. Continued use of a worn-out wheel may result in wheel explosion and serious personal injury. CAUTION: Before plugging in the tool, always check to see that the switch actuates properly and returns to the ``O (OFF)'' position when the rear of the switch lever is depressed. to start the tool , slide the switch lever toward the ``I (ON)'' position. For continuous operation, press the front of the switch lever to lock it. [. . . ] Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel. mount the inner flange onto the spindle. Fit the wheel on over the inner flange and screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. [. . . ]