User manual MAKITA AF500HP

[. . . ] Flush Too shallow Lock lever Slide backward Contact top cover Hole Protrusion Nose adapter Place first the contact element against workpiece. Hex wrench 3 Driver guide cover Screw Drain cock Air filter Oiler Pneumatic oil Thinner Stove Model Air pressure Nail length Nail capacity Dimensions (L X H X W) Min. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] The nail may be thrown and hit someone, or the tool itself can react dangerously. Do not leave the loaded tool or the air compressor under pressure for a long time out in the sun. Be sure that dust, sand, chips and foreign matter will not enter the tool in the place where you leave it setting. â· Do not point the ejection port at anyone in the vicinity. Keep hands and feet away from the ejection port area. â· When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. Handle the tool carefully, as there is high pressure inside the tool that can be dangerous if a crack is caused by rough handling (dropping or striking). Stop nailing operations immediately if you notice something wrong or out of the ordinary with the tool. Before performing any maintenance or repair. Before moving the tool to a new location. â· When not operating the tool, always lock the trigger by turning the lock lever to the LOCK position. â· Do not modify tool without authorization from Makita. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. â· Use only pneumatic tool oil specified in this manual. â· Never connect tool to compressed air line where the maximum allowable pressure of tool cannot be exceeded by 10%. Make sure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure. Do not attempt to keep the trigger contact element depressed with tape or wire. â· Always check contact element as instructed in this manual. Nails may be driven accidentally if the safety mechanism is not working correctly. The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 60 times per minute at a compression of 1. [. . . ] CAUTION: Always lock the trigger and disconnect the hose before loading the nailer. 15) To prevent the surface of workpiece from being scratched or damaged, use the nose adapter. Before attaching the nose adapter, remove two screws with the hex wrench that are securing the contact top cover. Attach the nose adapter so that its protrusion fit into the groove in the contact element. [. . . ]