User manual MAKITA AF550H

[. . . ] Sliding door Magazine Nail Groove for the sliding door Grooves at the bottom of the magazine Nail discharge opening Front driver guide Nose adapter Protrusion Holder Nose adapter Place first the contact element against workpiece. Holder Hex wrench Rear driver guide Screws Humid Hot Cap Drain cock Air filter Oiler Pneumatic oil Thinner Stove SPECIFICATIONS Model Air pressure Nail length Nail capacity Dimensions (L X H X W) Min. 3 Kg • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications may differ from country to country. [. . . ] accidental firing can be extremely dangerous. Handle the tool carefully, as there is high pressure inside the tool that can be dangerous if a crack is caused by rough handling (dropping or striking). Do not attempt to carve or engrave on the tool. Stop nailing operations immediately if you notice something wrong or out of the ordinary with the tool. Always disconnect the air hose and remove all of the nails: 1. Before performing any maintenance or repair. Before moving the tool to a new location. Perform cleaning and maintenance right after finishing the job. When not operating the tool, always lock the trigger by turning the lock lever to the LOCK position. Do not modify tool without authorization from Makita. Ask Makita’s Authorized service centers for periodical inspection of the tool. 8 • To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. €¢ Use only pneumatic tool oil specified in this manual. €¢ Never connect tool to compressed air line where the maximum allowable pressure of tool cannot be exceeded by 10%. Make sure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure. €¢ Do not attempt to keep the trigger contact element depressed with tape or wire. • Always check contact element as instructed in this manual. Nails may be driven accidentally if the safety mechanism is not working correctly. FUNCTIONAL DESCRIPTION CAUTION: • Always lock the trigger and disconnect the hose before adjusting or checking function on the tool. Checking before operation WARNING: • Never use the nailer when the safety elements are not in working order. Using it in that condition may cause a personal injuries and damage. [. . . ] Lock the trigger and slip the air socket of the air hose onto the air fitting on the nailer. Be sure that the air socket locks firmly into position when installed onto the air fitting. A hose coupling must be installed on or near the tool in such a way that the pressure reservoir will discharge at the time the air supply coupling is disconnected. OPERATION CAUTION: • Always be sure to first place the contact element against the workpiece before pulling the trigger. [. . . ]