User manual MAKITA AH1852

[. . . ] String Press Chip receiver Nut Shear blade Hooks Fit the hooks into groove Grooves Press the levers on both sides Unlock the hooks 21. Screws Under cover Sponge Washer Gear Sleeves Groove Blade cover Grease Blade SPECIFICATIONS Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage 829 mm 3. 18 V AH-1852 520 mm • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. [. . . ] € To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge. € To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. Install it fully until the red indicator cannot 7 IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE ENC009-1 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when installing the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. If you pull the switch trigger, the motor runs again but stops soon. In this situation, remove and recharge the battery. Switch action CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 2) For your safety, this tool is equipped with a dual switching system. To turn on the tool, press the lock-off button and triggers A and B. Release either one of the two pressed triggers to turn off. The sequence of switching is unimportant as the tool only starts when both switches are activated. battery protection system The tool is equipped with a battery protection system. This system automatically cuts off power to the motor to extend battery life. battery protection system The tool is equipped with a battery protection system. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the trigger switch again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again. [. . . ] NOTE: The washer underneath the gear may come off by mistake when removing the gear. In this case, return it to the original position as it was installed. Removing or installing shear blade CAUTION: • Before removing or installing shear blade, always be sure that the tool is switched off and the battery cartridge is removed. € When replacing the shear blade, always wear gloves without removing blade cover so that hands and face does not directly contact the blade. [. . . ]