User manual MAKITA AR410HR

[. . . ] Safety glasses Face shield Deep Shallow Sunk too deeply (turn to raising side) Appropriate Raised too high (turn to sink side) Hook Screw Knob Lever Magazine cap Screw channel Lead screw 15. Model Air pressure Screw length Screw capacity Safety Device Drive Adjustment Screw Feed Mechanism Min. Due to our continuing program of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Be sure that dust, sand, chips and foreign matter will not enter the tool in the place where you leave it setting. Do not point the ejection port at anyone in the vicinity. Keep hands and feet away from the ejection port area. When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. accidental firing can be extremely dangerous. Handle the tool carefully, as there is high pressure inside the tool that can be dangerous if a crack is caused by rough handling (dropping or striking). do not attempt to carve or engrave on the tool. Stop screw-driving operations immediately if you notice something wrong or out of the ordinary with the tool. (12) Before moving the tool to a new location. Do not modify tool without authorization from Makita. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. â· Use only pneumatic tool oil specified in this manual. â· Never connect tool to compressed air line where the maximum allowable pressure of tool cannot be exceeded by 10%. Make sure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure. â· Do not attempt to keep the trigger contact element depressed with tape or wire. â· Always check contact element as instructed in this manual. Screws may be driven accidentally if the safety mechanism is not working correctly. Proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced. When adjusting driving depth, always lock the trigger and disconnect the air hose. When adjusting driving depth, always lock the trigger and disconnect the air hose. This driver is equipped with an adjuster for adjusting screw driving depth. [. . . ] Here, do not release the trigger until the motor stops running. Note that if the trigger is released too soon, the screw may not be driven in flush to workpiece, and/or the screw feed may be impaired. Always disconnect the air hose from the tool before attempting to perform inspection or maintenance. When rectifying screw jam, always lock trigger, and disconnect air hose. [. . . ]