User manual MAKITA AT1826H

[. . . ] Lock-off button Switch trigger Indication lamp Shaft Grip Nylon cutting head Guard Screws Cutter cover Nylon cord eyehole 21. Notch of the nylon cutting head installation port 22. Lock button SPECIFICATIONS Model No load speed Overall length Cutting diameter with nylon cutting head Net weight Rated voltage Standard battery cartridge(s) Warning: Use only the battery cartridge(s) described. 18 V AP-18 • Due to our continuing program of research and development, the specifications herein are subject to change without notice. [. . . ] It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F). 2) FUNCTIONAL DESCRIPTION WARNING: • Always be sure that the tool is switched off and battery cartridge is removed before adjusting or checking function on the tool. Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. Installing or removing battery cartridge CAUTION: • Hold the tool and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge firmly may cause them to slip off your hands and result in damage to the tool and battery cartridge and a personal injury. € Always switch off the tool before installing or removing the battery cartridge. To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge. 3) To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. Install it fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. NOTE: • Do not use force when installing the battery cartridge. [. . . ] OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Dolmar tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Dolmar Service Center. [. . . ]