User manual MAKITA AT3623

[. . . ] Knob Handle clamp Handle holder Compression spring Barrier Spacer Cutter blade Guard Nylon cutting head Guard extension Bolt Wing Two bolts Protector cover Hex wrench Receive washer Clamp washer Cup 35. Hex nut Threaded spindle Lever Buckle Hanger Grease hole Gear case Cover Latches Press Spool For left hand rotation Notches Eyelets Protrusion (Not shown) Slot of the eyelet SPECIFICATIONS Model Type of handle No load speed Overall length Cutting blade diameter Cutting diameter with nylon cutting head Net weight Rated voltage Standard battery cartridge(s) Warning: Use only the battery cartridge(s) described. 9 kg • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. [. . . ] If the cutting tool is locked by entangling weeds or the like, always remove the battery cartridge before clearing it. Ask your local authorized service center for repairs. overheat protector is shutting off the power - overheating. Bump feeding at a high RPM may cause damage to the nylon cutting head. € The bump feed will not operate properly if the head is not rotating. 14) The nylon cutting head is a dual string trimmer head provided with a bump & feed mechanism. To cause the nylon cord to feed out, the cutting head should be bumped against the ground while rotating at a low RPM. As the nylon cord is feeding out it will automatically be cut to the proper length by the cutters on the guard extension. NOTE: If the nylon cord does not feed out while bumping the head, rewind/replace the nylon cord by following the procedures described under “Maintenance. € Battery remaining capacity indicator (only for models with Battery AP-3622) Battery AP-3622 is equipped with the battery remaining capacity indicator. 15) Press the CHECK button to indicate the battery remaining capacity. The indicator lamps will then light for approx. 011713 located between the grip/barrier assembly and the hanger. Position the barrier on the left side of the tool. Then tighten four screws so that the grip/barrier assembly cannot move or rotate on the shaft pipe. WARNING: • Do not remove or shrink the spacer. The spacer keeps a certain distance between both hands. Setting the grip/barrier assembly close to the other grip beyond the length of the spacer may cause loss of control and serious personal injury. 19 & 20) WARNING: • Never use the tool without the guard illustrated in place. Failure to do so can cause serious personal injury. CAUTION: • While installing the guard extension be careful not to contact the sharp nylon cord cutter provided on the guard extension. Contact with the cutter could result in personal injury. [. . . ] Cutting tool and motor cannot stop: Remove the battery immediately! 010824 Electric or electronic malfunction. OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Dolmar tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]