User manual MAKITA BDA341

[. . . ] Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. [. . . ] If not, it may accidentally fall out of the tool, causing injury to you or someone around you. â· Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Always be sure that the side grip is installed securely before operation. screw the side grip on the tool securely. The side grip can be installed on either side of the tool, whichever is convenient. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Be sure to hold the tool firmly before the tool is switched off. Hold the tool firmly with one hand on the gripping part of the tool and the other hand on the side grip when performing the tool. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. â· There is a tremendous force exerted on the tool/bit at the time of hole break through. Hold the tool firmly and exert care when the bit begins to break through the workpiece. â· A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. [. . . ] To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. [. . . ]