User manual MAKITA BDF448

[. . . ] Screw Limit mark Rear cover Screws Arm Spring Recessed part Carbon brush cap Hole SPECIFICATIONS Model Drilling into steel Capacities Drilling into wood Fastening wood screw Fastening machine screw No load speed (min-1 ) Overall length Net weight Rated voltage 2. 18 V BDF448 13 mm 65 mm 8 mm x 75 mm 6 mm 0 - 2, 000 0 - 400 BDF458 13 mm 76 mm 10 mm x 90 mm • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Intended use ENE034-1 The tool is intended for drilling and screw driving in wood, metal and plastic. [. . . ] 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. 6 The lamp goes out 10 -15 seconds after releasing the trigger. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. NOTE: • The adjusting ring does not lock when the pointer is positioned only halfway between the graduations. Empty signal for remaining battery capacity (Fig. 9) Stop the tool and with the tool stopped press the button on the switch panel and the remaining battery capacity will be signaled on the panel. The status displayed on the switch panel and the remaining battery capacity is shown in the following table. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. €¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. €¢ When not operating the tool, always set the reversing switch lever to the neutral position. Be sure that the speed change lever is set to the correct position before operation. CAUTION: • Always set the speed change lever fully to the correct position. about 20 % - 50 % Speed change (Fig. €¢ Do not use the speed change lever while the tool is running. 012023 About less than 20 % NOTE: • Before checking the remaining battery capacity, be sure to stop the tool. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. [. . . ] 15) Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use a screwdriver to remove two screws then remove the rear cover. [. . . ]