User manual MAKITA BFL400F

[. . . ] It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. [. . . ] ⷠWhen not operating the tool, always set the reversing switch lever to the neutral position. this tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The light automatically goes out 10 seconds after the switch trigger is released. nOTE: · Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Led indicator / Beeper on the tool shows the following functions. For approximately one second after auto-stop fastening, the tool does not start even if the switch trigger is pulled. Lights up in green for approximately one second. Warning against insufficient fastening Warning for battery cartridge capacity Checking the remaining battery capacity, Auto-stop Check the LED indicator, light and beeper operation Insufficient fastening has been performed when the switch trigger has Lights up in released before reaching the preset fas- red. This indicates the appropriate time to replace the battery cartridge when the battery power becomes low. This function works when the battery power is almost used up. This function works to check the proper operation of the LED indicator, light and beeper when a battery cartridge has been inserted into the tool. This function works when an abnormal drop of the battery voltage occurs for some reason and the tool stops. This function works if the temperature of the controller or motor increases to a high level and the tool stops. This function works to avoid the tool's immediate start upon insertion of battery cartridge into the tool with the switch trigger being pulled. [. . . ] These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita service center. [. . . ]