User manual MAKITA BFR550

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Screw strip No load speed (RPM) Overall length Net weight Rated voltage Standard battery cartridges · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Keep handles dry, clean and free from oil and grease. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to screwdriver safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always stop tool operation and charge the battery cartridge when you notice less tool power. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. [. . . ] Driving in corner This tool can be used to drive at a position 15 mm (5/8") away from the wall as shown in the figure. CAUTION: Driving at a position closer than 15 mm (5/8") to the wall or driving with the stopper base in contact with the wall may damage the screw heads and cause wear on the bit. This may also lead to poor fastening of screws and malfunction of the tool. Hold the tool squarely and firmly up against the driving surface. [. . . ]