User manual MAKITA BHP453RHJ

[. . . ] Save all warnings and instructions for future reference. sPECIFIC SAFETY RULES GEB003-4 SAVE THESE INSTRUCTIONS. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to hammer drill safety rules. [. . . ] For rotation with hammering, turn the ring so that the arrow points toward the mark on the ring. For rotation with clutch, turn the ring so that the arrow points toward the mark on the ring. CAUTION: • Always set the ring correctly to your desired mode mark. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. installing or removing battery cartridge (FIg. 1) • Always switch off the tool before insertion or removal of the battery cartridge. € To remove the battery cartridge, withdraw it from the tool while sliding the button on the side of the cartridge. € To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. 6) The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are 5 aligned with the arrow on the tool body. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. NOTE: • When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. Nominal diameter of wood Recommended size of pilot screw (mm) hole (mm) 3. 4 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. installing or removing driver bit or drill bit (FIg. 7) Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. [. . . ] Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. € Drill bits • Tungsten-carbide tipped hammer bit • Phillips bit • Slotted bit • Socket bit • Blow-out bulb • Safety goggles • Various type of Makita genuine batteries and chargers • Rubber pad assembly • Wool bonnet • Foam polishing pad • Plastic carrying case For Model BHP343 For European countries only Noise ENG104-1 The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 80 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). Vibration ENG203-2 The vibration total value (tri-axial vector sum) determined according to EN60745: Work mode: impact drilling into concrete Vibration emission (ah, ID): 10 m/s2 Uncertainty (K): 2. [. . . ]