User manual MAKITA BHP454RFE

[. . . ] ENGLISH INSTRUCTION MANUAL Cordless Hammer Driver Drill BHP444 BHP454 008997 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. 1 ENGLISH SPECIFICATIONS Model Concrete Steel Capacities Wood Wood screw Machine screw No load speed (min ) Blows per minute (min ) Overall length Net weight Rated voltage · Note: Specifications may differ from country to country. END004-2 ENG203-1 -1 -1 BHP444 14 mm 13 mm 50 mm 6 mm x 75 mm 6 mm 0- 1, 700 0 - 400 0 - 25, 500 0 - 6, 000 243 mm 2. 1 kg D. C. 14. 4 V BHP454 16 mm 13 mm 65 mm 10 mm x 89 mm High (2) Low (1) High (2) Low (1) 2. 2 kg D. C. [. . . ] Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. SAVE THESE INSTRUCTIONS. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. ENC007-2 FUNCTIONAL DESCRIPTION · IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. (3) Do not expose battery cartridge to water or rain. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1 2 1. 3. 4. 3 008993 · · 5. · 6. · 7. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. [. . . ] · Always secure small workpieces in a vise or similar hold-down device. · If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. First, slide the action mode change lever so that it points to the marking. The adjusting ring can be aligned in any torque levels for this operation. [. . . ]