User manual MAKITA BHR200SAE(1)

[. . . ] Cordless Rotary Hammer Equipped with Electric Brake 20 mm (13/16") MODEL BHR200 003091 INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Concrete Capacities Steel Wood No load speed (RPM) Blows per minute Overall length Net weight Battery Charger Input Output Battery Cartridge Voltage Charging time 30 min. BH2420 BH2433 BHR200 20 mm (3/4") 13 mm (1/2") 27 mm (1-1/16") 0 - 1, 100/min. [. . . ] Sound of cooling air comes out during cooling, which means no trouble on the charger. Yellow light will flash for warning in the following cases. - Trouble on cooling fan - Incomplete cool down of battery, such as, being clogged with dust The battery can be charged in spite of the yellow warning light. But the charging time will be longer than usual in this case. Check the sound of cooling fan, vent on the charger and battery, which can be sometime clogged with dust. · · · Cooling system (DC24SA only) · · 9 · The cooling system is in order although no sound of cooling fan comes out, if the yellow warning light will not flash. Always keep clean the vent on charger and battery for cooling. The products should be sent to repair or maintenance, if the yellow warning light will frequently flash. · · Conditioning charge (DC24SA only) Conditioning charge can extend the life of battery by automatically searching the optimum charging condition for the batteries in every situations. The battery employed in the following conditions repeatedly, will be worn out shortly, and yellow warning light may flash. Recharge of battery with its high temperature 2. Recharge of battery with its low temperature 3. Over-discharge of battery (continue to discharge battery in spite of down of power. ) The charging time of such battery is longer than usual. Trickle charge (Maintenance charge) If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its "trickle charge (maintenance charge)" mode and keep the battery cartridge fresh and fully charged. Tips for maintaining maximum battery life 1. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life. Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F). Let a hot battery cartridge cool down before charging it. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. 10 003104 Switch action · CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 1 1. Switch trigger To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. [. . . ] 809 Farmers Branch, TX 75234 (972) 243-1150 12701 Directors Dr. Stafford, TX 77477-3701 (281) 565-8665 3453 IH-35 North, Ste. 101 San Antonio, TX 78219 (210) 228-0676 MASSACHUSETTS 232 Providence Hwy. Westwood, MA 02090 (781) 461-9754 COLORADO 11839 E. [. . . ]