User manual MAKITA BJS101

[. . . ] Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. It can cause serious accident by electric shock. Only for EU countries Do not dispose of electric equipment or battery pack together with household waste material!In observance of European Directive 2002/96/EC on waste electric and electronic equipment, 2006/66/EC on batteries and accumulators and waste batteries and accumulators and their implementation in accordance with national laws, electric equipment and battery pack that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. [. . . ] â· Switch can be locked in "ON" position for ease of operator comfort during extend use. For continuous operation, press the front of the switch lever to lock it. Indication lamps are located in two positions. - Battery cartridge replacing signal - When the battery power is almost used up during operation, the red lamp lights up and the tool stops immediately. Replace the battery with fully charged one when the red lamp lights up. - Accidental re-start preventive function - Even if the battery cartridge is inserted on the tool with the slide switch in the "I (ON)" position, the tool does not start. At this time, the lamp flickers slowly and this shows that the accidental re-start preventive function is at work. - To start the tool, first slide the slide switch toward the "O (OFF)" position and then slide it toward the "I (ON)" position. Always stop tool operation and charge the battery cartridge when you notice less tool power. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. For BJS160 and BJS161 only Adjust the clearance between the side blade and the center blade according to the thickness of the workpiece. There may be a slight difference between clearance of both sides of the center blade. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. The following reference tables indicate the approximate service life of the blades. When the blades become dull, ask Makita Authorized Service Centers to replace the blades. After adjusting the clearance, tighten the screw securely. Store the hex wrench as shown in the figure when not in use. Before operation, lubricate the contact point of the center blade and the pin. To keep good cutting performance, also use a cutting lubricant from time to time during operation. Turn the tool on and set front ends of the side blades on the workpiece. [. . . ] For Model BJS161 For European countries only ENG104-1 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). 5 m/s2 For Model BJS100 For European countries only ENG104-1 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). 5 m/s2 For Model BJS101 For European countries only ENG104-1 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). EC Declaration of Conformity ENH101-12 We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Metal Shear Model No. [. . . ]