User manual MAKITA BLS713

[. . . ] Be sure that you understand their meaning before use. To avoid injury from flying debris, keep holding the saw head down, after making cuts, until the blade has come to a complete stop. When performing slide cut, first pull carriage fully and press down handle, then push carriage toward the guide fence. Do not place hand or fingers close to the blade. [. . . ] Press the shaft lock to lock the spindle and use the socket wrench to loosen the hex bolt clockwise. If the inner flange is removed be sure to install it on the spindle with its protrusion facing away from the blade. if the flange is installed incorrectly the flange will rub against the machine. To install the blade, mount it carefully onto the spindle, making sure that the direction of the arrow on the surface of the blade matches the direction of the arrow on the blade case. Install the outer flange and hex bolt, and then use the socket wrench to tighten the hex bolt (lefthanded) securely counterclockwise while pressing the shaft lock. Return the blade guard and center cover to its original position. Then tighten the hex bolt clockwise to secure the center cover. Release the handle from the raised position by pulling the stopper pin. Lower the handle to make sure that the blade guard moves properly. Make sure the shaft lock has released spindle before making cut. If the screw to secure the vise arm contacts the guide fence, install the screw on the opposite side of vise arm. Make sure that no part of the tool contacts the vise when lowering the handle fully and pulling or pushing the carriage all the way. if some part contacts the vise , re-position the vise. Press the workpiece flat against the guide fence and the turn base. The workpiece must be secured firmly against the turn base and guide fence with the vise during all operations. If the workpiece is not properly secured against the fence the material may move during the cutting operation causing possible damage to the blade, causing the material to be thrown and loss of control resulting in serious personal injury. The horizontal vise can be installed on the left side of the base. By turning the vise knob counterclockwise, the screw is released and the vise shaft can be moved rapidly in and out. By turning the vise knob clockwise, the screw remains secured. To grip the workpiece, turn the vise knob gently clockwise until the projection reaches its topmost position, then fasten securely. If the vise knob is forced in or pulled out while being turned clockwise, the projection may stop at an angle. In this case, turn the vise knob back counterclockwise until the screw is released, before turning again gently clockwise. [. . . ] If the pointer does not point to 0°, loosen the screw which secures the pointer and adjust the pointer so that it will point to 0°. Lower the handle fully and lock it in the lowered position by pushing in the stopper pin. loosen the lever at the rear of the tool. Turn the 0° bevel angle adjusting bolt (lower bolt) on the right side of the arm two or three revolutions counterclockwise to tilt the blade to the right. [. . . ]