User manual MAKITA BO5021K

[. . . ] Intended use The tool is intended for the sanding of large surface of wood, plastics and metal materials as well as painted surfaces. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed Safety instructions. [. . . ] 3 & 4) After emptying the dust bag, insert the hook on the dust nozzle into the rectangular hole on one side of the dust bag frame and push up the dust bag frame until it clicks into place on the push button. Installing paper dust bag To install the paper dust bag, place the paper dust bag on the paper dust bag holder with its front side upward. Insert the front fixing cardboard of the paper dust bag into the groove of the paper dust bag holder. 6) Then press the upper part of the front fixing cardboard in arrow direction to hook it onto the claws. 7) Insert the notch of the paper dust bag into the guide of the paper dust bag holder. Then install the paper dust bag holder set on the tool. Turn the tool on and wait until it attains full speed. then gently place the tool on the workpiece surface. Keep the pad flush with the workpiece and apply slight pressure on the tool. cAUTION: · Never run the tool without the abrasive disc. ON-LOAD The sanding pad rotates clockwise during the loaded operation, but it may rotate counterclockwise during the no-load operation. Install the front grip on the tool so that its protrusions fit into the matching notches in the front of the tool. Secure the front grip using a screwdriver to tighten the screw through the hole in the front grip. Use only a Makita genuine sponge pad, felt pad or wool pad (optional accessories). ⷠAlways operate the tool at low speed to prevent work surfaces from heating abnormally. Run the tool at low speed to smooth out wax. nOTE: · First, wax a not conspicuous portion of the work surface to make sure that the tool will not scratch the surface or result in uneven waxing. ⷠAlways run the tool at low speed. Running it at high speed may cause the wax to spatter. Run the tool at low speed to remove wax. [. . . ] CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. [. . . ]