User manual MAKITA BPT350

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Pin nail size Pin nail magazine capacity Dimensions (L x W x H) Net weight Rated voltage Standard battery cartridges · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Pin nails may rip through and/or fly off, presenting a grave danger. Watch your footing and maintain your balance with the tool. Make sure there is no one below when working in high locations. Use only pin nails specified in this manual. The use of any other pin nails may cause malfunction of the tool. Do not tamper with the tool or attempt to use it for other than driving pin nails. Do not operate the tool without pin nails. it shortens the service life of the tool. Stop driving operations immediately if you notice something wrong or out of the ordinary with the tool. Never drive pin nails into any materials which may allow the pin nail to puncture and fly through as a projectile. Never actuate the switch trigger and safety lever at the same time until you are prepared to drive pin nails on workpieces. Never defeat its purpose by securing the safety lever back or by depressing it by hand. Check the safety lever frequently for proper operations. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the Lithium-ion battery cartridge when you do not use it for more than six months. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. [. . . ] After driving a pin-nail, be sure to release the trigger fully. When the head of driven pin-nail remains above the surface of , drive the pin-nail while holding the pin nailer head firmly. Take out pin nails that remain inside the magazine. Loosen bolt (A) and bolt (B) by turning them approximately two turns using the hex wrench provided with the pin nailer. [. . . ]