User manual MAKITA BSR730

[. . . ] 1 To avoid kickback, do support board or panel near the cut. 2 Don't support board or panel away from the cut. 3 A typical illustration of proper hand support and workpiece support. 4 Button 5 Battery cartridge 6 Battery charger 7 Charging lights 8 Terminal cover 9 Hex wrench 0 Loosen (counterclockwise) q Shaft lock W e r t y u i o p a s d f g h Saw blade Outer flange Bolt Inner flange Setting protuberances Hex socket head bolt Cutting depth Lever Clamp screw Lever Slant surface Base Adjusting screw for 90° Adjusting screw for 45° Triangular rule j k l ; z x c v b n m , . [. . . ] Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. Ensure that the diameter, thickness and other characteristics of the saw blade are suitable for the tool. Ensure that the saw blade is suitable for the spindle speed of the tool. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the side of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Two charging lights will flash in green color repeatedly. Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of charger can be opened with inserting and closed with pulling out the battery cartridge. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will keep lighting up lit steadily during charging. One red charging light indicates charged condition in 0 ­ 80% and two red ones indicates 80 ­ 100%. With finish of charge, the charging lights will change from two red ones to two green ones. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its ``trickle charge (maintenance charge)'' mode which will last approximately 24 hours. After charging, unplug the charger from the power source. This charger is equipped with cooling fan for heated battery in order to enable the battery to prove its own performance. [. . . ] Be sure the blade is installed with teeth pointing up at the front of the tool. Use the hex wrench to loosen the hex socket head bolt for the riving knife adjustment, then raise the safety cover (safety guard). Move the riving knife up or down over the protuberance for settings indicated in Fig. 12, so as to obtain the proper clearance between the riving knife and saw blade. [. . . ]