User manual MAKITA BST110

[. . . ] Do not point the ejection port at anyone in the vicinity (especially his face). Keep hands and feet away from the ejection port area. Always remove the battery cartridge before loading the staples, adjustment, inspection, maintenance or after operation is over. Make sure no one is nearby before operation. [. . . ] Charge the Lithium-ion battery cartridge when you do not use it for more than six months. Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before carrying out any work on the pin nailer. If the staples have been handled roughly, they may be bent out of shape, causing poor staple feed or jamming. Do not use staples other than designated in this manual or staples that appear to be damaged, bent, rusty or corroded. â· Do not insert staples of which size is different each other at the same time inside the magazine, causing poor staple feed or jamming. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. â· To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. â· Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. 6) Load staples into the main magazine with their feet facing up. With the magazine loaded, if the tool is held downward and the sub-magazine is opened, the staples can fall out and present a danger to anyone or anything below. Keep this in mind especially when working in high locations. When removing staples, make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed from the stapler. Misfiring may cause personal injuries and property damage. Take out staples from the magazine slit. Make sure all safety systems are in working order before operation. [. . . ] When the head of driven staple remains above the surface of material to be fastened, drive the staple while holding the stapler head firmly. When the trigger is pulled after a quick trigger action, the stapler may do nothing but operates momentarily and may not fire staples. At this time, release the trigger once, pull it again and the staples can be fired. â· Using the stapler continuously with the head of driven staples remaining above the surface of material to be fastened may cause damage to the driver of the stapler and stapler jamming etc. [. . . ]