User manual MAKITA BST220

[. . . ] Never actuate the switch trigger and safety lever at the same time until you are prepared to staple workpieces. Allow the workpiece to depress the safety lever. Never defeat its purpose by securing the safety lever back or by depressing it by hand. Check the safety lever frequently for proper operations. [. . . ] If this occurs, point the tool well away from yourself or any bystanders. Release and pull the trigger again to make sure the safety systems are in working order. Always make sure that your fingers are not placed on the trigger and the battery cartridge is removed before carrying out any work on the stapler. If the staples have been handled roughly, they may be bent out of shape, causing poor staple feed or jamming. Do not use staples other than designated in this manual or staples that appear to be damaged, bent, rusty or corroded. â· Do not insert staples of which size is different each other at the same time inside the magazine , causing poor staple feed or jamming. Always stop tool operation and charge the battery cartridge when you notice less tool power. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 3) Load staples into the main magazine with their feet facing up. With the magazine loaded, if the tool is held downward and the sub-magazine is opened, the staples can fall out and present a danger to anyone or anything below. Keep this in mind especially when working in high locations. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. â· To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. When removing staples, make sure that your fingers are not placed on the trigger or the lever and the 5 Misfiring may cause personal injuries and property damage. 5) Take out staples from the magazine slit. Always make sure that the trigger are released and the battery cartridge is removed before removing jammed staples . Take out stuck staples that remain inside the opening that staples are fired from as it appears. Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before using the hook. [. . . ] There is a convenient sight window on the right side of the tool (when viewing the tool from the front). Use this sight window to check if there are staples in the magazine. When staples are not visible through the window, load staples into the magazine. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ]