User manual MAKITA BST221

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Staple width Applicable staples length Staple magazine capacity Overall length Net weight Rated voltage Standard battery cartridges · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Always remove the battery cartridge before loading the staples, adjustment, inspection, maintenance or after operation is over. Make sure no one is nearby before operation. Never attempt to drive staples from both the inside and outside of wall at the same time. Staples may rip through and/or fly off, presenting a grave danger. Watch your footing and maintain your balance with the tool. Make sure there is no one below when working in high locations. Use only staples specified in this manual. The use of any other staples may cause malfunction of the tool. Do not tamper with the tool or attempt to use it for other than driving staples. Do not operate the tool without staples. it shortens the service life of the tool. Stop driving operations immediately if you notice something wrong or out of the ordinary with the tool. Never staple into any materials which may allow the staple to puncture and fly through as a projectile. Never actuate the switch trigger and safety Lever at the same time until you are prepared to staple workpieces. Allow the workpiece to depress the safety lever. Never defeat its purpose by securing the safety lever back or by depressing it by hand. Check the safety lever frequently for proper operations. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. Always stop tool operation and charge the battery cartridge when you notice less tool power. Read and understand tool labels and manual. [. . . ] Take out staples from the magazine slit. CAUTION: Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before using the hook. If the staples are driven too deep or too shallow, adjust the driving depth by turning the nut on the bottom of the tool. For deeper driving of staples, turn the nut clockwise. [. . . ]