User manual MAKITA BTD133 ANNEXE 695

[. . . ] Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. [. . . ] ⷠTo remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. Maximum blows Application BTD133 3, 200 (min­1) BTD145 3, 400 (min­1) Tightening when force and speed are desired. Tightening when a good finishing is needed. Tightening when excessive tightening need to be avoided because of potentially clogged female screw and broken or damaged screw head. Tightening sash screw / Tightening small screws such as M6. The hammering force can be changed in three steps: hard, medium and soft. this allows a tightening suitable to the work. Every time the hammering force button is pressed, the number of blows changes in three steps. For approximately one minute after releasing the switch trigger, the hammering force can be changed. nOTE: · When all lamps on the switch panel go out, the tool is turned off to save the battery power. The hammer force grade can be checked by pulling the switch trigger to the extent that the tool does not operate. ⷠDuring the operation of switch trigger, the hammer force grade cannot be changed. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Pulling the trigger switch when the remaining battery capacity becomes very low makes LED indicator flicker. If the tool is used continuously with the LED indicator flickering up and the battery power is almost used up, the LED indicator will light up and the tool itself will stop. 10) A = 17 mm B = 14 mm A = 12 mm B = 9 mm To install these types of bits, follow the procedure (1). To install these types of bits, follow the procedure (2). Procedure 1 For tool without one-touch type To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Procedure 2 In addition to the procedure (1) above, insert the bit-piece into the sleeve with its pointed end facing in. To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out. nOTE: · If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. [. . . ] These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. [. . . ]