User manual MAKITA BTD142

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Machine screw Capacities Standard bolt High tensile bolt No load speed (RPM) Impacts per minute Overall length Net weight Rated voltage Standard battery cartridge · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Keep handles dry, clean and free from oil and grease. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to impact driver safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Number of blow Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. [. . . ] To remove, loosen the screw and then take it out. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. nOTE: · Use the proper bit for the head of the screw/bolt that you wish to use. ⷠWhen fastening screw M8 or smaller, carefully adjust pressure on the switch trigger so that the screw is not damaged. [. . . ]