User manual MAKITA BTD144

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Machine screw Capacities Standard bolt High tensile bolt Hammer mode (Hard) No load speed (RPM) Hammer mode (Medium) Hammer mode (Soft) Hammer mode (Hard) Impacts per minute Hammer mode (Medium) Hammer mode (Soft) Overall length Net weight (with battery cartridge) Rated voltage Standard battery cartridge · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. With the light button in the ON status, pull the switch trigger to turn on the light. To turn off, release it and the light goes out approximately 10 seconds after releasing. With the light button in the OFF status, even if the trigger is pulled, the lamp will not light on. nOTE: · To make sure the status of light, pull the trigger. [. . . ] ⷠIf the LED indicator flickers and the tool stops even with a recharged battery cartridge, stop using and have the tool repaired by a Makita local service center. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. [. . . ]