User manual MAKITA BTP140

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Fastening torque Machine screw Capacities Impact driver mode High tensile bolt No load speed (RPM) Impacts per minute No load speed (RPM) Hammer drill mode Blows per minute Capacities No load speed (RPM) Low (1) Drill mode Steel Capacities Wood No load speed (RPM) Screw driver mode Capacities Overall length Net weight Rated voltage Standard battery cartridge Machine screw M4 186 mm (7-3/8") 1. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Be careful not to scratch the lens of lamp, or it may lower the illumination. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. cAUTION: Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When not operating the tool, always set the reversing switch lever to the neutral position. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Select one of the four modes suitable for your work needs by using this lever. For rotation with impact, turn the lever so that the arrow on the lever points toward the mark on the tool body. Before operation, always make sure that the lever is correctly set to your desired mode mark and use the tool at an appropriate speed for your work. [. . . ] Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use a screwdriver to remove two screws then remove the rear cover. Reinstall the rear cover and tighten two screws securely. [. . . ]