User manual MAKITA BTW151

[. . . ] Be sure no one is below when using the tool in high locations. The proper fastening torque may differ depending upon the kind or size of the bolt. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. [. . . ] â· Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. â· When not operating the tool, always set the reversing switch lever to the neutral position. this tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the socket. For socket without O-ring and pin To install the socket, push it onto the anvil of the tool until it locks into place. For socket with O-ring and pin Move the O-ring out of the groove in the socket and remove the pin from the socket. Fit the socket onto the anvil of the tool so that the hole in the socket is aligned with the hole in the anvil. This tool has a convenient auto-stop mechanism that allows you to preset the desired number of impacts in terms of the application. The tool then stops automatically after reaching the preset number of impacts. To set the dial on the back of the tool, first slide out the battery cartridge by sliding the button on the side of the cartridge. Two dials can be seen on the battery holder side. You cannot set the auto-stop setting for fastening with more than 200 impacts (over 4 sec. ) Note: Do not force the dial when turning. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Tool stops after the twice Pull the trigger to start the Bolt fastening while controlthe set number of impacts tool; release it to stop. Pull the trigger to start the tool; release it to stop. Bolt fastening without controlling the number of impacts; or when fastening with more than 200 impacts (over 4 sec. Temporary bolt fastening and loosening By using the B or C on the left dial in combination with one of the digits (from 0 to 9) on the right-hand dial, you can do temporary bolt fastening or bolt loosening. After catching the first Pull the trigger to start the For temporary bolt fastenimpact, tool stops [*] x 0. [. . . ] Both identical carbon brushes should be replaced at the same time. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]