User manual MAKITA BVC350

[. . . ] Stop operation immediately if you notice anything abnormal. Do not bring close to stoves or other heat sources. do not block the intake hole or vent holes. Do not leave the cleaner when battery fitted. [. . . ] The cleaner stops during operation when the cleaner and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the cleaner trouble. ⷠWhen the cleaner is overloaded: At this time, press the "OFF" button and remove causes of overload and then press the "HIGH/LOW" button again to restart. ⷠWhen battery cells get hot: (refer to the note below. ) If any operation of the "HIGH/LOW" button and the "OFF" button, the motor will remain stopped. At this time, stop use of the cleaner and cool or charge the battery cartridge after removing it from the cleaner. ⷠWhen the remaining battery capacity gets low: If any operation of the "HIGH/LOW" button and the "OFF" button, the motor will remain stopped. At this time, remove the battery cartridge from the cleaner and charge it. nOTE: · This temperature-sensitive protection is applied only when the cleaner is used with a battery cartridge with a star mark. The first press on this button is for high speed and the second press for low speed and then each press on this button repeats the high/low speed cycle alternatively. Do not use the shoulder strap when working in a high place. Always be sure that the cleaner is switched off and the battery cartridge is removed before carrying out any work on the cleaner. ⷠAny work with the battery cartridge being installed on the cleaner may cause a personal injury or damage to the objects around the cleaner. When using the cleaner as a portable cleaner, crosshanging the shoulder strap before the breast is difficult to drop the cleaner. nOTE: · Long cut-off decorative paper that may be produced by plaster board cutting work depending on the conditions of workpiece to be cut and that may be stuffed inside the hose may cause the hose suction blocking. When this occurs, change the cutting depth setting of power tool to deeper depth, which will relieve the hose suction blocking. cAUTION: · When the dust bag is just new, dust may come out of its surface. Using it a few times will minimize the dust leak from the surface. Hold the square section of the dust bag joint and fit the pins inside the dust bag joint to the notches in the dust outlet of the cleaner and then insert and turn it clockwise all the way until it stops. At this time, make sure that the fastener part on the dust bag faces upward. nOTE: · When the dust bag joint and the ring inside the dust bag come off, install as follows. (1) Align the dust bag joint with the seam of the dust bag and install it so that its protrusion faces upward. [. . . ] Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. The typical A-weighted noise level determined according to EN60745: Model BVC340 Sound pressure level (LpA): 81 dB (A) Sound power level (LWA): 92 dB (A) Uncertainty (K): 3 dB (A) Model BVC350 Sound pressure level (LpA): 84 dB (A) Sound power level (LWA): 95 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection Always be sure that the cleaner is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. Do not pick up materials other than dust, such as stone, wood chip and the like since this cleaner is intended for dust collection. [. . . ]