User manual MAKITA CC300D

[. . . ] Buttons Battery Clamping screw Depth guide Bevel scale plate Cutting line Lock-off lever Switch trigger Shaft lock Hex wrench 11. No load speed (n0) / Rated speed (n) Overall length Rated voltage Net weight Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Specifications and battery cartridge may differ from country to country. Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Intended use ENE025-1 The tool is intended for cutting in glass and masonry materials with a diamond wheel and water. [. . . ] Do not position your body in line with the rotating wheel. Use special care when working corners, sharp edges etc. Do not attach a saw chain, woodcarving blade, segmented diamond wheel with a peripheral gap greater than 10 mm or toothed saw blade. Do not attempt to make an excessive depth of cut. When wheel is binding or when interrupting a cut for any reason, switch off the power tool and hold the power tool motionless until the wheel comes to a complete stop. Never attempt to remove the wheel from the cut while the wheel is in motion otherwise kickback may occur. Let the wheel reach full speed and carefully re-enter the cut. The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece. Support panels or any oversized workpiece to minimize the risk of wheel pinching and kickback. Large workpieces tend to sag under their own weight. Supports must be placed under the workpiece near the line of cut and near the edge of the workpiece on both sides of the wheel. Use extra caution when making a "pocket cut" into existing walls or other blind areas. The protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause kickback. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Before using battery cartridge, read all instructions and cautionary markings on (1) 5 It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. [. . . ] If a inner flange is removed by chance, install the inner flange so that its protrusion (bigger side) faces inside as shown in the figure. Be sure to hold the workpiece firmly down on a stable bench or table during operation. Do not twist or force the tool in the cut, or the motor may be overloaded or the workpiece may break. Do not use the tool with the diamond wheel in an upward or sideways position. [. . . ]