User manual MAKITA DA4030

[. . . ] Model Speed Auger bit Capacities Wood Steel No load speed (RPM) Overall length *With Extended spade grip Net weight · Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. cAUTION: Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Two speed ranges can be preselected with the speed change knob. To change the speed, depress the lock button and turn the speed change knob so that the pointer points to the position 1 for low speed or the position 2 for high speed. CAUTION: Use the speed change knob only after the tool comes to a complete stop. Changing the tool speed before the tool stops may damage the tool. Always set the speed change knob carefully into the correct position. If you operate the tool with the speed change knob positioned halfway between the position 1 and the position 2, the tool may be damaged. The side grip can be installed on either side of the tool, whichever is convenient. The spade grip can be installed in any position as shown in the figure. To change the position, loosen the hex bolts (both sides) with a hex wrench and turn the spade grip to the desired position. [. . . ] when reversing , brace the tool to prevent a clockwise reaction. If the bit must be removed from a partially drilled hole, be sure the tool is properly braced before reversing. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. [. . . ]