User manual MAKITA DBC3310

[. . . ] Read and understand this Owner's and Safety Manual. Always follow safety precautions in the Owner's and Safety Manual. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. We trust that you will be a satisfied customer. [. . . ] When installing the chisel type saw blade make sure that the direction of rotation arrows on saw blade and on cutter guard are pointing in the same direction! important: The locknut (K/3) has a plastic insert protection. For safety reasons, this nut must be replaced immediately if it becomes loose. It must be replaced in any event after 10 tool changes at the latest (order no. Always install the metal cutter guard when installing the chisel type saw blade!Unscrew the locknut (K/3) from the shaft by turning it clockwise. Screw the locknut (M/3) onto the shaft by hand. Press the locking button (M/9) and hold it down while using the combination wrench to turn the shaft counter-clockwise until the locking button engages and locks the shaft. Now tighten the locknut counter-clockwise using the combination wrench (25-30 Nm). press the release button (M/10) to unlock the shaft. The locking button (M/9) will jump out (if necessary turn the saw blade slightly). Check to make sure the saw blade can turn freely. In order to achieve easier operation along slopes and fitches, it is possible to swivel the gear box (N/13) from the normal position to either side by approximately 45 degrees. adjustment: Loosen the two screws (N/14). Loosen screw (N/15) enough to turn the gear box in the direction indicated by the arrow until the three boreholes are visible at the main tube. Turn the gear box in the direction indicated until the position of the screw (N/15) matches up with the borehole. Move the gear box back again and tighten the first screw (N/15) and subsequently the remaining two screws (N/14) by the same amount. Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Refuel either in a well ventilated room or outdoors. Fuel vapours are poisonous and can be hazardous to your health. Avoid eye and skin contact with fuels and mineral oils. [. . . ] Guarantee claims can be recognized only if this work is performed regularly and properly. Clean Check for damage and sharpness Check (cutting tool must not move) Empty Run empty The maintenance and repair modern brushcutters and safety-related components and assemblies requires qualified technical training and a workshop equipped with special tools and testing devices. We therefore recommend that you consult a MAKITA service centre for all work not described in this instruction manual. The MAKITA service centres have all the necessary equipment and skilled and experienced personnel, who can work out costeffective solutions and advise you in all matters. [. . . ]