User manual MAKITA DDF456RFJ

[. . . ] Rear cover Recessed part Spring Arm Carbon brush cap Hole Carbon brush cap SPECIFICATIONS Model Steel Capacities Wood Wood screw Machine screw No load speed (min-1 ) High (2) Low (1) BDF446 13 mm 38 mm 6 mm x 75 mm M6 0 - 1, 500 0 - 400 192 mm 1. 18 V Overall length Net weight Rated voltage • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. € Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Intended use ENE034-1 The tool is intended for drilling and screw driving in wood, metal and plastic. [. . . ] The lamp goes out 10 -15 seconds after releasing the trigger. 5 NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 9) The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. 5) CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. installing bit holder (Optional accessory) (Fig. 10) Fit the bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. When not using the driver bit, keep it in the bit holders. OPERATION CAUTION: • Always insert the battery cartridge all the way until it locks in place. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Hold the tool firmly with one hand on the grip and the other hand on the bottom of the battery cartridge to control the twisting action. [. . . ] CAUTION: • Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. € There is a tremendous force exerted on the tool/bit at the time of hole break through. Hold the tool firmly and exert care when the bit begins to break through the workpiece. [. . . ]