User manual MAKITA DF331DWAE

[. . . ] 18 4 ENGLISH (Original instructions) SPECIFICATIONS Model: Drilling capacities Fastening capacities No load speed Overall length Rated voltage Battery cartridge Net weight BL1015, BL1020B 1. 1 kg Steel Wood Wood screw Machine screw High (2) Low (1) 189 mm D. 1 mm x 63 mm M6 0 - 1, 700 min-1 0 - 450 min-1 157 mm DF031D • • • Due to our continuing program of research and development, the specifications herein are subject to change without notice. Specifications and battery cartridge may differ from country to country. [. . . ] In this situation, remove and recharge the battery. CAUTION: Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out approximately 10 seconds after releasing the switch trigger. NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination.  Reversing switch lever] CAUTION: Always check the direction of rotation before operation. CAUTION: Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. CAUTION: When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Indicating the remaining battery capacity Only for battery cartridges with "B" at the end of the model number [Fig.  Check button] Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light up for few seconds.  Speed change lever] Lighted CAUTION: Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned halfway between the "1" side and "2" side, the tool may be damaged. CAUTION: Do not use the speed change lever while the tool is running. NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. ENGLISH 7 Position of speed change lever 1 2 Speed Torque Applicable operation Heavy loading operation Light loading operation Low High High Low To change the speed, switch off the tool first. [. . . ] CAUTION: Make sure that the driver bit is inserted straight in the screw head, or the screw and/or driver bit may be damaged. Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts in. [. . . ]