User manual MAKITA DP4001

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Steel Capacities Wood No load speed (RPM) Overall length Net weight 32 mm (1-1/4") 0 - 1, 200/min. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance instructions may create a risk of electric shock or injury. USE PROPER EXTENSION CORD: Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to drill safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold tool by insulated gripping surfaces when performing an operation where the cutting tools may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Always be sure you have a firm footing. Be sure no one is below when using the tool in high locations. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. For continuous operation, pull the switch trigger and then push the lock lever upward. To stop the tool from the locked position, pull the switch trigger fully, then release it. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. When using the hook, pull it out in A direction and then push it in B direction to secure in place. [. . . ] Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. place the point of the bit in the indentation and start drilling. [. . . ]