User manual MAKITA DP4003K

[. . . ] This tool should be grounded while in use to protect the operator from electric shock. Use only three-wire extension cords which have three-prong grounding-type plugs and three-pole receptacles which accept the tool's plug. For Model DP3002/DP3003 For European countries only Noise and Vibration The typical A-weighted sound pressure level is 80 dB (A). The noise level under working may exceed 85 dB (A). [. . . ] Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of these devices can reduce dust-related hazards. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source and/ or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 3. Electrical safety 4. 5. 6. 7. 8. Personal safety 9. 3 19. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Follow instruction for lubricating and changing accessories. [. . . ] Adjust the depth gauge to the desired depth and tighten the side grip. NOTE: · The depth gauge cannot be used at the position where the depth gauge strikes against the tool body. 1 1. Depth gauge OPERATION 003076 Holding tool When drilling a large hole with a hole saw, etc. , the side grip (auxiliary handle) should be used as a brace to maintain safe control of the tool. Grasp the rear handle and the front grip firmly when starting or stopping the tool, since there is an initial and final reaction. [. . . ]