User manual MAKITA DS5000

[. . . ] Intended use The tool is intended for drilling in wood, metal and plastic. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. [. . . ] In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. Hold the tool firmly and exert care when the bit begins to break through the workpiece. ⷠA stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. However, the tool may back out abruptly if you do not hold it firmly. (For Models DS4011 and DS5000) · Always secure small workpieces in a vise or similar hold-down device. ⷠAvoid drilling in material that you suspect contains hidden nails or other things that may cause the bit to bind or break. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Tool speed is increased by increasing pressure on the switch trigger. For continuous operation, pull the switch trigger, push in the lock button and then release the switch trigger. To stop the tool from the locked position, pull the switch trigger fully, then release it. Change the direction of rotation only when the tool comes to a complete stop. Changing it before the tool stops may damage the tool. the switch is reversible , providing either clockwise or counterclockwise rotation. To start the tool, simply pull the lower part of the switch trigger for clockwise or the upper part for counterclockwise. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Place the chuck key in each of the three holes and tighten clockwise. Be sure to tighten all three chuck holes evenly. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Drill Model No. / Type: DS4010, DS4011, DS5000 are of series production and Conforms to the following European Directives: 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd. [. . . ]