User manual MAKITA EG671AE

[. . . ] When disposing this product , make sure that the fuel and oil should be drained from the engine , and submit to local regulations. Thank you very much for purchasing a MAKITA GENERATOR. this manual covers operation and maintenance of the MAKITA GENERATOR. This MAKITA GENERATOR can be used for general electrical equipments, appliances, lamps, tools as an AC power source. [. . . ] (f) After the engine started, return the choke lever gradually to "OPEN" position. - ) CHOKE LEVER CLOSE OPEN (g) Warm up the engine without a load for a few minutes. (c) Set choke lever to close if the engine is cold. Make sure that the appliance is switched OFF before connecting it to the generator. Do not move the generator while it is running. Be sure to ground the generator if the connected appliance is grounded. Failure to ground unit may lead to electrical shock. If the generator does not produce the specified voltage, consult your nearest Makita factory or authorized service center. (b) Turn off the switch (es) of the electrical appliance (s) before connecting to the generator. Be sure to ground the generator if the connected electrical device is grounded. When the AC circuit breaker turns off during operation, the generator is over loaded or the appliance is defective. Stop the generator immediately, check the appliance and / or generator for overloading or detect and have repaired as necessary by Makita factory or authorized service center. Check the amperage of the receptacles, and be sure not to take a current exceeding the specified amperage. Be sure that the total wattage of all appliances dose not exceed the rated output of the generator. 3A (100W) of maximum AC power can be taken out from the DC receptacle by means of the exclusive DC cable. DC Circuit Breaker DC circuit breaker is turned off to shut down the DC power, when the DC is over the usage range or the battery is defective. Check the generator and/or battery for overloading or defect, and turn on the DC circuit breaker after no problem and defect are found out. Do not put foreign objects into the plug receptacle. (a) Turn off the power switch of the electric equipment and unplug the cord from receptacle of the generator. (b) Allow the engine about 3 minutes to cool down at no-load before stopping. 8) Make sure that the pilot lamp is turned on. Do not use both AC and DC output at the same time. [. . . ] Check for loose bolts and screws, tighten them if necessary. Clean generator thoroughly with oiled cloth. Pull starter handle until resistance is felt, leaving handle in that position. Store generator in a well ventilated, low humidity area. [. . . ]