User manual MAKITA EK7301

[. . . ] packing Your MAKITA Power Cutter is packed in a cardboard box to prevent shipping damage. Cardboard is a basic raw material and is consequently reuseable or suitable for recycling (waste paper recycling). Instruction manual (not shown) 1 In case one of the parts listed should not be included in the delivery inventory, please consult your sales agent. Symbols You will notice the following symbols on the saw and in the Instruction Manual: Read instruction manual and follow the warning and safety precautions! [. . . ] IMPORTANT: • After tightening/inspection, make certain to tighten the hex. 11 9 12 10 Before operating 1. Checking/replenishing engine oil • With the engine in a cool state, check/replenish engine oil in the following way. €¢ Position engine on a flat level, and check to see whether oil is within the range of MAX and MIN of the oil tank. €¢ If oil is insufficient (near the MIN mark of the oil tank), fill the oil tank with oil to the MAX mark. €¢ Oil quantity can be checked externally without removing the oil cap as the oil level can be seen at the external, see-through, measuring mark window. €¢ For reference, oil needs to be replenished every ten operating hours (one tank of oil for ten fuel refuels).  se API grade SF class or higher SAE U 10W-30 oil (automobile 4-stroke engine oil). 22 L (220 mL) NOTE: • If the engine is not stored in the upright position, oil will circulate through the engine, which will mean that there will be excessive oil in the Power Cutter when replenishing. €¢ If oil exceeds the MAX mark, it may leak out causing dirtying or white smoke. Oil replacement Point 1 <Oil cap> Interval of replacement: Initially, after 20 operating hours, and subsequently every 30 operating hours. <Fuel> The engine is a four-stroke engine, so use automobile gasoline (regular gasoline/petrol) to run the engine. Fuel MAX Fuel tank Fuel points • Do not use a gasoline mixture (engine oil mixed with gasoline). Doing so may cause carbon build up and mechanical failure. €¢ The use of old fuel may cause poor engine startup. <Refueling> Always stop the engine and let it cool down before refueling. Automobile gasoline (petrol) • Slightly loosen the fuel tank cap to release pressure and thus equalize external and internal air pressure. • Remove fuel tank cap and refuel. (Do not fill to the top of the tank neck. Therefore, if it shows wear or other abnormalities, replace it. (Rough guide to replacement is once every two or three years. ) Oil tank cap Fuel tank cap Level 15 Operating Starting WARNING: Do not start the engine in locations where refueling has taken place. [. . . ] The dealer or service center authorized by Makita will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of Makita. WHAT IS NOT COVERED *  Conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by Makita during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services. *  The replacement parts used for required maintenance services. [. . . ]