User manual MAKITA ELM3311

[. . . ] Front wheel Motor cover Lower handle Cable hook Switch handle The rear wheel cover The rear wheel The rear wheel support 17. The front wheel cover The front wheel The front wheel support Rear cover Level indicator Indicator light KNOW YOUR LAWN MOWER Read this manual carefully, observing the recommended safety instructions before, during and after using your lawn mower. Following these simple instructions will also maintain your lawn mower in good working order. Familiarize yourself with the controls on your mower before attempting to operate it, but above all, be sure you know how to stop your mower in an emergency. [. . . ] 33) Children should be supervised to ensure that they do not play with the appliance. 34) This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 35) If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. 36) Instructions for the safe operation of the appliance, including a recommendation that the appliance should be supplied via a Residual Current Device (RCD) with a tripping current of not more than 30 mA. 37) Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. 38) Always allow the machine to cool before storing. 39) When servicing the blades be aware that, even though the power source is switched off, the blades can still be moved. 40) Replace worn or damaged parts for safety; Use only genuine replacement parts and accessories. 41) Be careful during adjustment of the appliance to prevent entrapment of the fingers between moving blades and fixed parts of appliance. 42) Before use check the supply and extension cord for signs of damage or worn. If the cord becomes damaged during use, disconnect the cord from the supply immediately. dO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY. Do not use the appliance if the cord is damaged or worn. 43) If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. TECHNICAL DATA Model: Rated voltage: Rated frequency: Rated power: No load speed: Cutting width: Guaranteed sound power level: LpA (SPL) at the site of the user: Guaranteed vibration: Grass catcher capacity: Net weight: Degree of protection against liquid: Height adjustment : ELM3311 230 V~ 50 Hz 1, 100 W 2, 900/min 330 mm 96 dB (A) 75. ASSEMBLY 5-1 ASSEMBLE THE WHEEL Insert the axle of front and rear wheel cover into the wheel and then screw into the hole of wheel support. ADJUSTMENT OF CUTTING HEIGHT The cutting height is adjusted by attaching the wheels to the required hole. The height (the blade to the ground) can be adjusted from 20 mm to 55 mm (3 height positions). 13) The lowest adjustment: 20 mm (position (1)); the middle adjustment: 40 mm (position (2)); the highest adjustment: 55 mm (position (3)). WARNING: All wheels must be at the same height. 5-2 ASSEMBLE THE FOLDING HANDLE A) Insert the lower handlebars into the fixed holes of the underpan, and then fixed with supplied screw by a screwdriver. 5) B) Connect the upper handle and the lower handle with the locking lever. [. . . ] 21) To remove the blade (2), unscrew the blade screw (3). 24) Check the conditions of the fan (1), and replace any parts, which are damaged. 22) When reassembling, make sure that the cutting edges face in the direction of the motor rotation. The blade screw (3) must be tightened to torque 20-25 Nm. [. . . ]