User manual MAKITA EVH2000

[. . . ] Important: Read this instruction manual carefully before putting the into operation and strictly observe the safety regulations!Thank you very much for purchasing a MAKITA POWER SPRAYER. We are pleased to offer you a product that is the result of an extensive development program and many years of knowledge and experience. To safely obtain the best possible results from your MAKITA POWER SPRAYER, please read this manual thoroughly before using the machine, and follow all instructions given herein to ensure proper operation. [. . . ] Measured Sound Power: 98 dB Guarantee Sound Power: 102 dB These sound power levels wear measured in accordance with Council Directive, 2000/14/EC. Model Displacement Fuel Fuel tank capacity Engine oil Engine oil capacity Caburetor Ignition system Spark plag Electrode gap L type type type mm L cm3 EH025A 24. 5 SAE 10-W-30 oil API SF or later (4-stroke automobile engine oil) 0. Sound pressure level (Lpa) to 98/37/EC Guaranteed sound power level (Lwa) to 2000/14/EC Note: 1. Use the oil and spark plug specified by MAKITA. This specification is subject to change without prior notice. DESIGNATION OF PARTS I-O Switch Throttle lever Choke lever Air cleaner cover Plug cover Starter knob Fuel tank Fuel tank cap CAUTION: Before performing any work on the power sprayer, always switch off the motor and pull the spark plug connectors off the spark plug. CAUTION: Start the power sprayer only after having assembled it completely. Be careful to put parts together properly to prevent leaks. Set the two shoulder harnesses on a chemical tank in a way shown below without any twists of the shoulder harnesses. Instructions are given about the ones for one of the shoulder harnesses. Pull the harness in the direction of the arrow and put its folded end at the lower end of the buckle. Put the part 'A', of the harness through this gap of the metallic hook. Metallic hook Repeat the same instructions for the other shoulder harness to finish the setting. One of the twooverlapped harnesses, at the metallic hook in a way shown below at and . ­ Perform the following procedure, with the engine cooled down. ­ While keeping the engine level, remove the oil gauge, and confirm that the oil is filled within the upper and lower limit marks. When the oil is in short in such a way that the oil gauge touches the oil only by its tip, in particular with the oil gauge remaining inserted in the crankcase without screwing-in (Fig. ­ For reference, the oil refill time is about 10h (10 times or 10 tanks of oil refill). ­ If the oil changes in color or mixes with dirt, replace it with new one. (For the interval and method of replacement, refer to P 16) Recommended oil: SAE 10W-30 oil of API Classification, Class SF or higher (4-stroke engine for automobile) Oil volume: Approx. If the engine is not kept upright, oil may go into around the engine, and may be refilled excessively. [. . . ] ­ Use a piece of paper to wipe off any oil adhering to the air cleaner cover and plate breather. ­ Immediately after cleaning, attach the cleaner cover and use the attachment bolt for fixing. (When remounting, position the upper part of the cover first and then the lower. Place cut part in this position (top left) ­ The gap between the two electrodes of the spark plug should be 0. [. . . ]