User manual MAKITA EW320TR ANNEXE 75

[. . . ] The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines/ generators complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U. To the engines/generators exported to and used in the countries other than the U. , warranty service shall be performed by the distributor in each country in accordance with the standard engine/generator warranty policy as applicable. [. . . ] Upper level Lower level Do not refuel while smoking or near open flame or other such potential fire hazards. Incline the engine as fuel inlet upward, then refill fuel to the upper level. (EW120R) Close the fuel cock before filling the fuel tank. (EW220R, EW320TR) Do not fill above the top of the fuel filter screen (marked LEVEL), or the fuel may overflow when it heats up later and expands. (EW220R , EW320TR) When filling the fuel tank , always use the fuel filter screen. Wipe off any spilled fuel before starting the engine. It is recommended that the water chamber of pump casing should be primed with full of water before operating. Never attempt to operate the pump without priming water or the pump will overheat. Extended dry operation will destroy the mechanical seal. If the unit has been operated dry, stop the engine immediately and allow the pump to cool before adding priming water. Set the speed control lever 1/3 of the way towards the high speed position. If the engine is cold, or the ambient temperature is low, close the choke lever fully. If the engine is warm or the ambient temperature is high, close the choke half-way, or keep it fully open. Return the handle to its original position and pull swiftly. After starting the engine, allow the starter handle to return to its original position while still holding the handle. (f) After starting the engine, gradually open choke by turning the choke lever and finally keep it fully opened. Do not fully open the choke lever immediately when the engine is cold or the ambient temperature is low, because the engine may stop. (a) After the engine starts, set the speed control lever at the low speed position (L) and warm it up without load for a few minutes. Whenever high speed operation is not required, slow the engine down (idle) by moving the speed control lever to save fuel and extend engine life. (b) Gradually move the speed control lever toward the high speed position (H) and set it at the required engine speed. (a) Set the speed control lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. Set the speed control lever at the low speed position and allow the engine to run at low speed for 1 or 2 minutes before stopping. [. . . ] be careful to avoid damaging the screen. The spark arrester must be free of breaks and holes. ) Drop in engine output (Consult your nearest dealer. Pump dose not selfprime (Consult your nearest dealer. [. . . ]