User manual MAKITA G2400R

[. . . ] Important: Read the instruction handbook before using the machine. Keep other people at a safe distance whilst working. Warning: Remove the spark plug lead and read instructions before carrying out any repair or maintenance. Do not put hands or feet near the blades. [. . . ] regular maintenance is essential for safety and performance. 2) Never store the equipment with fuel in the tank inside a building where vapour may reach a flame or a spark or a source of extreme heat. 3) Allow the engine to cool before storing in an enclosed space. 4) To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms. 5) Check the stone-guard and grass-catcher frequently for wear and deterioration. 6) If the fuel tank has to be drained, this should be done outdoors and when the engine is cool. 7) Wear strong work gloves when removing and reassembling the blade. 8) Keep the blade balanced during sharpening. All operations on the blade (dismantling, sharpening, balancing, remounting and/or replacing) require a certain familiarity and special tools. regular maintenance is essential for safety and performance. 1 Return the lower part of the handle, which is made up of two pre-assembled elements (1), to its working position and lock into place using the lower knobs (2). Attach the upper part (3) using the screws (4) supplied, ensuring that the spiral (5) of the starter cable is in the correct position. Attach the control cables using the clips (6). By loosening the knobs (2) the handle can be set at three different heights. With the plastic part (11) upside-down, fasten the frame (12) to the plastic part using the screws (13). Insert the frame (12) into the sack (14) and attach the plastic profile (15) with the help of a screwdriver, as shown in the drawing. Fit the edge of the cloth (16) right into the groove of the plastic part (11), starting 5-7 mm from the ends. Assemble the dashboard (1) following the steps 4. ROUTINE MAINTENANCE IMPORTANT – Regular, careful maintenance is essential for keeping the safety level and original performance of the machine unchanged in time. 1) Wear strong working gloves during any cleaning, maintenance or adjustment operation on the machine. 2) Carefully clean the machines with water after each cut; remove the grass debris and mud accumulated inside the chassis to avoid their drying and thus making the next start-up difficult. [. . . ] IMPORTANT - Do not touch the speed changer when the engine is stopped. This operation could damage the speed changer. 1 Lift the stone-guard and attach the grass-catcher (1) correctly as shown in the drawing. Should you have any doubts or problems, do not hesitate to contact your nearest Service Centre or your Dealer. [. . . ]