User manual MAKITA G3200N

[. . . ] ⷠWeight according to EPTA-Procedure 01/2003 Intended use ENE028-1 The tool is intended for performing lengthways and crossways straight cuts and mitre cuts with angles in wood while in firm contact with the workpiece. Never hold piece being cut in your hands or across your leg. secure the workpiece to a stable platform. It is important to support the work properly to minimize body exposure, blade binding, or loss of control. [. . . ] Wait until blade stops before grasping cut material. Inspect for and remove all nails from lumber before cutting. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. 5 illustrates the RIGHT way to cut off the end of a board, and Fig. If the workpiece is short or small, clamp it down. Before setting the tool down after completing a cut, be sure that the lower guard has closed and the blade has come to a complete stop. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Do not stop the blades by lateral pressure on the saw blade. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Be careful not to drop or strike battery. Lithium-ion batteries with a star marking are equipped with a protection system. This system automatically cuts off power to the tool to extend battery life. The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions: · overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the trigger switch on the tool and stop the application that caused the tool to become overloaded. Then pull the trigger switch again to restart. if the tool does not start , the battery is overheated. In this situation, let the battery cool before pulling the trigger switch again. ⷠLow battery voltage: The remaining battery capacity is too low and the tool will not operate. Always stop tool operation and charge the battery cartridge when you notice less tool power. [. . . ] Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the sawing is completed. To get clean cuts, keep your sawing line straight and your speed of advance uniform. If the cut fails to properly follow your intended cut line, do not attempt to turn or force the tool back to the cut line. Doing so may bind the blade and lead to dangerous kickback and possible serious injury. [. . . ]