User manual MAKITA GA 9030X01

[. . . ] Shaft lock Motor housing Lock button Handle Switch trigger Lock lever Wheel guard Screw Bearing box 10. Inner flange 78 Dust collecting wheel guard Exhaust vent Inhalation vent Commutator Insulating tip Carbon brush Brush holder cap Screwdriver SPECIFICATIONS Model Depressed center wheel diameter Spindle thread No load speed (min-1) Overall length Net weight Safety class 5. 5 kg • Due to our continuing program of research and development, the specifications herein are subject to change without notice. € Note: Specifications may differ from country to country. [. . . ] For tool with the lock on and lock-off switch To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction). For continuous operation, push in the lock lever (in the A direction), pull the switch trigger (in the B direction) and then push the lock lever (in the A direction) further in. To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it. nOTE: Models GA7030S , GA9030S , GA7040S , GA9040S , GA7030SF. GA9030SF, GA7040SF and GA9040SF begin to run slowly when they are turned on. this soft start feature assures smoother operation. SAVE THESE INSTRUCTIONS FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 4) CAUTION: • Always be sure that the side grip is installed securely before operation. Screw the side grip securely on the position of the tool as shown in the figure. 1) CAUTION: • Never actuate the shaft lock when the spindle is moving. Press the shaft lock to prevent spindle rotation when installing or removing accessories. 6 Installing or removing wheel guard (Fig. 5) CAUTION: • The wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around 180 degrees counterclockwise. To remove wheel guard, follow the installation procedure in reverse. Nut with its protrusion facing downward (facing toward the wheel). To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. To remove the wheel, follow the installation procedure in reverse. OPERATION WARNING: • It should never be necessary to force the tool. [. . . ] Only 1/3 of efforts needed to undo lock nut, compared with conventional type. For Australia and New Zealand Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange and screw the lock nut with its protrusion facing downward (facing toward the wheel). 9) To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. [. . . ]