User manual MAKITA GA6021Y

[. . . ] INSTRUCTION MANUAL MANUEL D'INSTRUCTION MANUAL DE INSTRUCCIONES Angle Grinder Meuleuse d'Angle Esmeriladora de Disco GA5020 GA5020C GA5020Y GA5021C GA6020 GA6020C GA6020Y 008074 WARNING: For your personal safety, READ and UNDERSTAND before using. 1 DOUBLE INSULATION DOUBLE ISOLATION DOBLE AISLAMIENTO ENGLISH SPECIFICATIONS Model Wheel diameter Spindle thread No load speed (RPM) Overall length Net weight 11, 000/min 356 mm (14") 2. 3 lbs) GA6020/GA6020Y 150 mm (6") GA6020C 150 mm (6") • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Note: Specifications may differ from country to country. [. . . ] Use of this tool to grind or sand some products, paints and wood could expose user to dust containing hazardous substances. use appropriate respiratory protection. After using the tool, make sure the wheel rotation comes to a complete stop before setting the tool down. Setting the tool down with the wheel rotating can cause personal injury. use appropriate respiratory protection. Ͻ¥ volts ï½¥ ï½¥ ï½¥ ï½¥ ï½¥ ï½¥ amperes alternating current alternating or direct current no load speed Class II Construction revolutions or reciprocation per minute FUNCTIONAL DESCRIPTION • CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Shaft lock 1 007991 CAUTION: Never actuate the shaft lock when the spindle is moving. Press the shaft lock to prevent spindle rotation when installing or removing accessories. • SAVE THESE INSTRUCTIONS. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Switch action • CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. If the tool consistently fails to quickly stop wheel after switch trigger release, have tool serviced at a Makita service center. 2 007992 Electronic function Constant speed control (For models GA5020C/GA5021C/GA6020C) • For tool without lock button and lock-off button To start the tool, simply pull the switch trigger. For tool with lock-off button To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, depress the lock-off button and pull the switch trigger. Switch trigger (type B) • Possible to get fine finish, because the rotating speed is kept constantly even under the loaded condition. When the load returns to admissible levels, the tool will operate as normal. Soft start feature • Soft start because of suppressed starting shock. Indication lamp B 008415 A 1 2 008416 For tool with the lock-on switch To start the tool, simply pull the switch trigger (A). For continuous operation, pull the switch trigger (A) and then push in the lock lever (B). To stop the tool from the locked position, pull the switch trigger (A) fully, then release it. For tool with the lock-off switch To prevent the switch trigger from accidentally pulled, a lock lever is provided. [. . . ] Regularly clean the tool's air vents or whenever the vents start to become obstructed. €¢ 008000 1 2 After replacing brushes, plug in the tool and break in brushes by running tool with no load for about 10 minutes. Then check the tool while running and electric brake operation when releasing the switch trigger. If electric brake is not working well, ask your local Makita service center for repair. [. . . ]