User manual MAKITA GA7030F

[. . . ] They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. The operation of this device under unfavorable mains conditions can have adverse effects to the operation of other equipment. With a mains impedance equal or less than 0. 23 Ohms it can be presumed that there will be no negative effects. [. . . ] To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it. nOTE: Models GA7030S , GA9030S , GA7040S , GA9040S , GA7030SF. GA9030SF, GA7040SF and GA9040SF begin to run slowly when they are turned on. Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Always be sure that the side grip is installed securely before operation. Never actuate the shaft lock when the spindle is moving. Press the shaft lock to prevent spindle rotation when installing or removing accessories. The wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around 180 degrees counterclockwise. To remove wheel guard, follow the installation procedure in reverse. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. Make sure that the arrow on the tool should point in the same direction as the arrow on the diamond wheel. mount the inner flange onto the spindle. Fit the diamond wheel on over the inner flange and screw the lock nut onto the spindle. Notice that flat side of the lock nut should face the diamond wheel in case the diamond wheel is used. The wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard around to the position shown in the figure. tighten the lever to fasten the wheel guard. If the lever is too tight or too loose to fasten the wheel guard, loosen or tighten the nut to adjust the tightening of the wheel guard band. [. . . ] ­ The typical weighted root mean square acceleration value is not more than 2. These values have been obtained according to EN50144. For Model GA9030, GA9030F, GA9030S, GA9030SF For European countries only Noise and Vibration The typical A-weighted noise levels are sound pressure level: 91 dB (A) sound power level: 104 dB (A) ­ Wear ear protection. ­ The typical weighted root mean square acceleration value is not more than 2. [. . . ]