User manual MAKITA GA7040S01

[. . . ] ENGLISH Angle Grinder MODEL GA7030, GA7030F MODEL GA7030S, GA7030SF MODEL GA7040S, GA7040SF MODEL GA9030, GA9030F MODEL GA9030S, GA9030SF MODEL GA9040S, GA9040SF 007051 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Depressed center wheel diameter Spindle thread No load speed (min-1) Overall length Net weight Safety class 5. 1 kg GA7030/GA7030F/ GA7030S/GA7030SF GA7040S/GA7040SF GA9030/GA9030F/ GA9030S/GA9030SF GA9040S/GA9040SF 180 mm M14 8, 500 511 mm 5. 5 kg /II 5. 1 kg 230 mm M14 6, 600 511 mm 5. 5 kg · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. · Note: Specifications may differ from country to country. Symbols END202-2 The following show the symbols used for the tool. [. . . ] Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. ADDITIONAL SAFETY RULES 1. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglassreinforced wheels. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Observe the instructions of the manufacturer for correct mounting and use of wheels. Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels. Use only flanges specified for this tool. Do not damage the spindle, the flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage. For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length. Before using the tool on an actual workpiece, test run the tool at the highest no load speed for at least 30 seconds in a safe position. Stop immediately if there is any vibration or wobbling that could indicate poor installation or a poorly balanced wheel. Check that the workpiece is properly supported. Make sure the wheel is not contacting the workpiece before the switch is turned on. Use the specified surface of the wheel to perform the grinding. Do not use cutting off wheel for side grinding. Hold the tool so that sparks fly away from you and other persons or flammable materials. Pay attention that the wheel continues to rotate after the tool is switched off. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. 3. [. . . ] This can cause loss of control and kickback. NEVER use tool with wood cutting blades and other sawblades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury. CAUTION: Never switch on the tool when it is in contact with the workpiece, it may cause an injury to operator. [. . . ]