User manual MAKITA HG650C

[. . . ] do not work in wet sanitary facilities. Avoid body contact with grounded cables or surfaces, such as pipes, radiators, ranges and refrigerators. WARNING: Connect power tools that are used in the open via a residual current circuit breaker (RCCB). Do not work on fuels or gas containers or in their vicinity, even when they are empty. [. . . ] Do not operate the flow reflection nozzle that is not suitable for your unit can lead to burns. Work and in case of doubt, abstain from using the hot air tool. Do not point the unit at the same spot for extended periods. Combustible materials that are hidden behind coverings, in ceilings, floors or cavities, and ignite them. Inspect the work area before starting to Unit when it is placed down horizontally or when pointed downward. The air-intake opening and the nozzle must not be covered. Use only nozzles that are suitable for your unit. recycle raw materials instead of disposing as waste. The unit, accessories and packaging should be sorted for environmentallyfriendly recycling. English - 7 IMPORTANT SAFETY INSTRUCTIONS* This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. Wash hands, arms and face and rinse mouth before eating or drinking. Do not smoke or chew gum or tobacco in the work area. Clean up all removed paint and dust by wet mopping the floors. Use a wet cloth to clean all walls, sills and any other surface where paint or dust is clinging. Use a high phosphate detergent or trisodium phosphate (TSP) to wash and mop areas. At the end of each work session put the paint chips and debris in a double plastic bag, close it with tape or twist ties and dispose of properly. Remove protective clothing and work shoes in the work area to avoid carrying dust into the rest to the dwelling. Wipe shoes off with a wet rag that is then washed with the work clothes. Wash hair and body thoroughly with soap and water. Air flow Weight Weight without cord with cord Dimensions LxBxH Protection class When observing the safety rules and using the original accessories, this hot air tool is intended for all applications with hot air that are listed in these operating instruction applications Shrinking of shrinkdown tubing , solder connectors and solder terminals , packaging and electrical components. Deforming of articles made from acrylic, PVC, and polystyrene, tubing, plates and profiles, as well as moist woods. [. . . ] Use only original nozzles according to the table that are suitable for your unit. Observe the mains voltage: The voltage of the power source must agree with the value given on the nameplate of the unit. Extension cords must have a conductor cross section of 2 x 1. When the unit has cooled off, set the switch 1 to 0. [. . . ]