User manual MAKITA HM0870C

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Blows per minute Overall length Net weight · Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Exposure to noise can cause hearing loss. Use auxiliary handle(s), if supplied with the tool. loss of control can cause personal injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety glasses. it is also highly recommended that you wear a dust mask and thickly padded gloves. Be sure the bit is secured in place before operation. under normal operation , the tool is designed to produce vibration. The screws can come loose easily, causing a breakdown or accident. check tightness of screws carefully before operation. In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Be sure no one is below when using the tool in high locations. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Volts amperes hertz alternating current Class II Construction revolutions or reciprocation per minute number of blow CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. It should be lubricated every time the carbon brushes are replaced. Send the complete tool to Makita Authorized or Factory Service Center for this lubrication service. [. . . ]